Product description
Split Hook for lifting
• Spread version
• High tensile steel
• Grooved contact surface
• Connecting link
• Finish: painted red
Notice on use for Plate Hook and Split Hook:
Plate hooks have the following specific features which distinguish them from regular hooks:
• The inclination angle must not exceed or fall below 20°.
• The chain length has to be adapted to the permissible inclination angle and the load.
• For lifting of stacked plates or similar loads at least 3 plate hooks must be used.
• For lifting of dimensionally stable tubes plate hooks may also be used in pairs.
• For lifting of long and slim materials it is advisable to work with a spreader beam and 4 plate hooks.
• The load has to rest on the full length of the hook. The hooks must not be loaded on the tips only!
• The load must be connected in such a way that it cannot slip or spring off the base of the hook when lifted or transported.
• The hooks must only be used to transport sheets, slabs or horizontal rings.
• Keep clear of suspended loads.